Kerio-tech Firewall6 Manual do Utilizador descarregar pdf (Página 68)

100

101

Chapter 7 Traﬃc Policy

Step 1 — information

Figure 7.1 Traﬃc Policy Wizard — introduction

To run successfully, the wizard requires the following parameters on the WinRoute host:

• at least one active adapter connected to the local network

• at least either one active adapter connected to the Internet or one dial-up deﬁned. This

connection is not required to be dialed at the moment of the wizard’s startup.

Steps 2 and 3— internet connection settings

On the second page of the wizard, select how the LAN will be connected to the Internet with

WinRoute (leased link, dial-up, leased link with connection failover or multiple links with net-

work traﬃc load balancing).

On the third page, you can set parameters for the selected type of Internet connection.

Individual options of Internet connection are addressed thoroughly in chapter 6.

Note:

1. Selection of Internet connection type does not aﬀect resulting traﬃc rules, but only con-

ﬁguration of interfaces and their classiﬁcation in groups (see chapters 5 and 6).

2. The Traﬃc Policy Wizard no longer includes the option to enable /disable IP address trans-

lation (NAT) which was available in older versions of WinRoute. In all created traﬃc rules,

NAT is enabled automatically. The reason for this is that modes of network load balancing,

connection failover and on-demand dialing cannot actually be used without NAT.

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 403 404

Comentários a estes Manuais

Sem comentários

Kerio-tech Firewall6 Manual do Utilizador Página 68

Comentários a estes Manuais